[c-nsp] Cisco 5k with HP flex Fabric

[Thomason, Simon]

Tried all of these things kind of lost on this one. Waiting to hear back from HP.


-----Original Message-----
From: Håvard Staub Nyhus [mailto:hnyhus at gmail.com]
Sent: Tuesday, 13 December 2011 11:16 PM
To: Thomason, Simon
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] Cisco 5k with HP flex Fabric

> Has anyone run into issues with adding new vlans to a VPC for HP blades? I have just provisioned a new network to pump down to my HP blades but have run into issues on the HP farm.

HP Flexfabric certainly feels like a black hole in the data center
network infrastructure. Are you sure the vlan is correctly provisioned
on the HP blades? It is certainly easy enough to misconfigure the
flexfabric with regards to failover.

What kind of channel protocol are you running? LACP? what does "show
port-channel summary" say? Is everything connected properly? Try
turning on LLDP on your Nexus and verify your connections...

--
Håvard Staub Nyhus
Network Consultant
+47 41 88 00 99


Stuck for gift ideas? Check out racq.com/shop where you are sure to find something for everyone.

Please Note: If you are not the intended recipient, please delete this email as its use is prohibited.  RACQ does not warrant or represent that this email is free from viruses or defects.  If you do not wish to receive any further commercial electronic messages from RACQ please e-mail unsubscribe at racq.com.au or contact RACQ on 13 19 05.
Please Note: 
If you are not the intended recipient, please delete this email as its use is prohibited. 
RACQ does not warrant or represent that this email is free from viruses or defects.
If you do not wish to receive any further commercial electronic messages from RACQ
please e-mail unsubscribe at racq.com.au or contact RACQ on 13 19 05.