[c-nsp] How to see interface configuration after card failure on ASR9K

[Vitkovsky, Adam]

When you pull out a linecard -the particular interfaces config will automatically be converted into the: "interface preconfigure gig 0/1/1"
Than you can go ahead and edit the interface config if you like before you insert the new card back using the "interface preconfigure" cmd in the config mode

Also when planning on inserting a brand new card you can preconfigure the interfaces for the particular card beefier the card is inserted


adam
-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Daniel Roesen
Sent: Wednesday, December 28, 2011 1:49 PM
To: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] How to see interface configuration after card failure on ASR9K

On Wed, Dec 28, 2011 at 01:37:34PM +0100, Vitkovsky, Adam wrote:
> Pre-configuration is possible with XR as well

So you can preconfigure interfaces, but not see and edit the
remembered config of interfaces which got physically removed (or
linecard shut down)?

Best regards,
Daniel

-- 
CLUE-RIPE -- Jabber: dr at cluenet.de -- dr at IRCnet -- PGP: 0xA85C8AA0
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/