[c-nsp] ASA 5505 doesn't like itself

[Tom Sutherland]

as a test, you might try:

icmp permit any inside
icmp permit any outside

from cisco command reference:

"To configure access rules for ICMP traffic that terminates at a
adaptive security appliance interface, use the icmp command."


On Thu, 2011-02-17 at 16:53 -0500, Michael Loether wrote:

> I have a ASA 5505 I am setting up at a small branch office.  Working towards a site to site VPN but first I need to get it to talk to itself.  Traffic is not passing from inside to outside.  
> 
> interface Vlan1
>  nameif inside
>  security-level 100
>  ip address 172.19.1.1 255.255.255.0 
> !
> interface Vlan2
>  nameif outside
>  security-level 0
>  ip address 64.183.175.22 255.255.255.252 
> !
> interface Ethernet0/0
>  switchport access vlan 2
> !
> interface Ethernet0/1
> !
> nat (inside,outside) after-auto source dynamic any interface
> 
> DHCPd is running on VL 1 and it is handing out IPs as expected.  
> 
> ping inside 64.183.175.21
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 64.183.175.21, timeout is 2 seconds:
> ?????
> Success rate is 0 percent (0/5)
> 
> ACLs are any any ip on both inside and outside.
> 
> Any suggestion would be appreciated.
> 
> Mike
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
-------------- next part --------------
A non-text attachment was scrubbed...
Name: smime.p7s
Type: application/x-pkcs7-signature
Size: 5037 bytes
Desc: not available
URL: <https://puck.nether.net/pipermail/cisco-nsp/attachments/20110225/b05317d7/attachment.bin>