[c-nsp] setting caller ID on sip calls (Cisco iad 2400)

[Scott Granados]

Hi,

I’m trying to set the outbound caller ID correctly when placing a call from a Cisco IAD 2400.

I have the following dial-peer entry

dial-peer voice 803 voip
description "E911 calling"
translation-profile outgoing STRIP9
destination-pattern 9911
session protocol sipv2
session target ipv4:a.b.c.d
codec g711ulaw
clid network-number 772-555-1212
!

When I dial, a different number (the main number is injected.

Does this overid the Caller ID data or if not is there a way to accomplish this?

I found the CLID entry in the command reference guide but was a little confused about number stripping or other bits that might need to be set.

Any pointers would be appreciated.

Thank you
Scott