[c-nsp] Subrate T3 card

[Alex Moya]

Does it give you the option to set up the controller?


On Jul 26, 2011, at 6:41 PM, Joseph Mays wrote:

> I have a T3/E3 card in a cisco 3640 that I want to use as a serialT3, but it does not show up as a serial interface, nor is there even a controller line in the config. It only shows up in the hardware infomration as a "Subrate T3/E3 port". What does this mean?
> 
> gw1.dist uptime is 1 hour, 36 minutes
> System returned to ROM by power-on
> System restarted at 17:00:56 EDT Tue Jul 26 2011
> System image file is "flash:c3640-is-mz.123-6.bin"
> 
> cisco 3640 (R4700) processor (revision 0x00) with 124928K/6144K bytes of memory.
> Processor board ID 11876053
> R4700 CPU at 100MHz, Implementation 33, Rev 1.0
> Bridging software.
> X.25 software, Version 3.0.0.
> SuperLAT software (copyright 1990 by Meridian Technology Corp).
> 2 FastEthernet/IEEE 802.3 interface(s)
> 2 Serial network interface(s)
> 1 Subrate T3/E3 ports(s)
> DRAM configuration is 64 bits wide with parity disabled.
> 125K bytes of non-volatile configuration memory.
> 24576K bytes of processor board System flash (Read/Write)
> 
> Configuration register is 0x2102
> 
> gw1.dist#
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/