[c-nsp] optic diag commands on 6500

[Edward Salonia]

Depending on IOS version and sfp's used, DOM may be useful to you.

Have a look here for compatible sfp's: http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_8031.html

#show int trans supported-mod
#show int trans supported-list

And as others have said:
#show int giX/X trans

- Ed
------Original Message------
From: Mandeep Singh
Sender: cisco-nsp-bounces at puck.nether.net
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] optic diag commands on 6500
Sent: Jun 10, 2011 3:27 PM


Hi,
Is there a similar command on the 6500s as on the Junipers below:
 
 show interfaces diagnostics optics xe-0/0/8 
Physical interface: xe-0/0/8
    Laser bias current                        :  39.304 mA
    Laser output power                        :  0.7050 mW / -1.52 dBm
    Module temperature                        :  41 degrees C / 106 degrees F
    Module voltage                            :  3.2490 V
    Receiver signal average optical power     :  0.1063 mW / -9.73 dBm
Thanks.
-Mandeep 		 	   		  
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/