[c-nsp] L3 Switch as a BGP Gateway

Murphy, Jay, DOH Jay.Murphy at state.nm.us
Tue Jun 28 13:36:39 EDT 2011


Yes, without full feeds, and allowing the provider to filter their routes, and you route statically to your provider. For Metro optical Ethernet, it is a deployable solution. Current BGP routes, roughly 350,000+, in addition to internal routes and what have you... that said, a BGP speaker used only for a network with a single point of entry to the Internet may have a much smaller routing table size--thus the modest requirements needed for RAM and CPU--than a multi-homed network. Even simple multi-homing can have modest routing table size.

~Jay Murphy 
Sr. IP Network Specialist
NM State Government
 
IT Services Division
PSB – IP Network Management Center
Santa Fé, New México 87505 

"We move the information that moves your world." 
“Engineering is about finding the sweet spot between what's solvable and what isn't."
“Good engineering demands that we understand what we’re doing and why, keep an open mind, and learn from experience.”
                                                                                                                                                                            Radia Perlman
"If human beings are perceived as potentials rather than problems, as possessing strengths instead of weaknesses, as unlimited rather than dull and unresponsive, then they thrive and grow to their capabilities."
                                                                                                                                                                         
 Please consider the environment before printing e-mail


-----Original Message-----
From: farisy at gmail.com [mailto:farisy at gmail.com] 
Sent: Monday, June 27, 2011 7:24 PM
To: Jay Hennigan; cisco-nsp-bounces at puck.nether.net; Murphy, Jay, DOH
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] L3 Switch as a BGP Gateway

Dear Jay,
As far as I know, IPv4 BGP entry is more than 300k entry, I don't think it will suite with a 3750.
Please refer to routing handling from its datasheet. 
I'm agree with the other, if you would run default gateway for multihomed upstream, 3750 will do.
Hope it help.


Rgrds,
-farisy-

-----Original Message-----
From: Jay Hennigan <jay at west.net>
Sender: cisco-nsp-bounces at puck.nether.net
Date: Mon, 27 Jun 2011 13:44:07 
To: Murphy, Jay, DOH<Jay.Murphy at state.nm.us>
Cc: cisco-nsp at puck.nether.net<cisco-nsp at puck.nether.net>
Subject: Re: [c-nsp] L3 Switch as a BGP Gateway

On 6/27/11 1:30 PM, Murphy, Jay, DOH wrote:
> How about when you stack them as a logical switch. Couldn't one leverage the memory and processing of the stacking?

If you're taking just a default eBGP route from each external neighbor
and using multi-homing as a primary/failover, you can get away with it.
 "Multi-homed BGP gateway" in your original post implies taking at least
a partial table from a diversity of transit providers and/or peers, and
these switches just aren't capable of dealing with anywhere near that
many routes.


> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Jay Hennigan
> Sent: Monday, June 27, 2011 1:11 PM
> To: cisco-nsp at puck.nether.net
> Subject: Re: [c-nsp] L3 Switch as a BGP Gateway
> 
> On 6/27/11 11:59 AM, Jason Greenberg wrote:
>> Can someone advise me as to why a 3750 L3 Switch (Metro Model) wouldn't outperform a 7300 series router as a multi-homed BGP gateway?  ISRs and Enterprise class routers are still quite a bit more expensive than the L3 Switches, but I'm starting to not understand why.   I understand that L3 switches are less feature rich on the routing end, but suppose that our ASAs are doing most of the complicated filtering.    I know it doesn't sound "right" to have a 3750G used in this manner, but I am having a hard time finding any real reason why not to do it.
> 
> The memory and number of routes are far too small to use these as a
> border router.  Generally adequate for iBGP to inject customer routes
> into your network but way too little for an Internet-facing border.

--
Jay Hennigan - CCIE #7880 - Network Engineering - jay at impulse.net
Impulse Internet Service  -  http://www.impulse.net/
Your local telephone and internet company - 805 884-6323 - WB6RDV
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/



More information about the cisco-nsp mailing list