[c-nsp] N5K with Generic Copper sfp

[Thomason, Simon]

Hey Chris,

Port is set to 1G but have not tried the command just yet. Not certain I am going as this is a production device and really do not want to have an event happen.


-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Chris Evans
Sent: Tuesday, 22 March 2011 11:17 AM
To: tvarriale at comcast.net
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] N5K with Generic Copper sfp

The command still works. You also need to configure speed 1000 under the
port.
On Mar 21, 2011 9:03 PM, "Tony Varriale" <tvarriale at comcast.net> wrote:
> On 3/21/2011 6:22 PM, Thomason, Simon wrote:
>> Hey All,
>>
>> Was just wondering if anyone has had much luck using generic copper sfp
in a nexus 5020? I have run into an issue with a generic SFP will not bring
the port up on my 5k but a Cisco one work first time.
>>
>> I do know that Cisco will say to use a Cisco sfp but there is a rather
big price difference between generic and cisco :(
>>
>>
>> ----log---
>> EMP31D12NEXUS# sh interface ethernet 1/16 transceiver
>> Ethernet1/16
>> sfp is present
>> name is OEM
>> type is 10Gbase-(unknown)
>> part number is GLC-T-CRB
>> revision is A1
>> serial number is TT1209160022
>> nominal bitrate is 1200 MBits/sec
>> Link length supported for copper is 100 m(s)
>> cisco id is --
>> cisco extended id number is 4
>> !
>> Eth1/16 TBA - 10.53.109.x/ down 314 full 1000 1/10g
>>
>>
>>
>> EMP31D12NEXUS# sh interface ethernet 1/16 transceiver
>> Ethernet1/16
>> sfp is present
>> name is CISCO-AVAGO
>> type is 10Gbase-(unknown)
>> part number is ABCU-5710RZ-CS4
>> revision is
>> serial number is AGM1327260K
>> nominal bitrate is 1300 MBits/sec
>> Link length supported for copper is 100 m(s)
>> cisco id is --
>> cisco extended id number is 4
>> !
>> Eth1/16 TBA - 10.53.109.x/ up 314 full 1000 1/10g
>> ----log---
>>
>> ---config---
>> interface Ethernet1/16
>> description TBA - 10.53.109.x/24
>> switchport access vlan 314
>> speed 1000
>> storm-control broadcast level 0.50
>> udld aggressive
>> channel-group 18 mode active
>> ---config---
>>
>> $50 off vehicle inspections
>> An RACQ vehicle inspection is great for new car buyers, or to check for
any faults before your warranty expires. Members get $50 off the retail
price. For more info visit
http://www.racq.com.au/motoring/cars/car_advice/vehicle_inspections
>>
>> Please Note: If you are not the intended recipient, please delete this
email as its use is prohibited. RACQ does not warrant or represent that this
email is free from viruses or defects. If you do not wish to receive any
further commercial electronic messages from RACQ please e-mail
unsubscribe at racq.com.au or contact RACQ on 13 19 05.
>>
>>
>> _______________________________________________
>> cisco-nsp mailing list cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
> The unsupported-transceiver used to work but it's been a long while. I
> suspect it's turned off now.
>
> tv
>
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/


$50 off vehicle inspections
 An RACQ vehicle inspection is great for new car buyers, or to check for any faults before your warranty expires. Members get $50 off the retail price. For more info visit http://www.racq.com.au/motoring/cars/car_advice/vehicle_inspections

Please Note: If you are not the intended recipient, please delete this email as its use is prohibited.  RACQ does not warrant or represent that this email is free from viruses or defects.  If you do not wish to receive any further commercial electronic messages from RACQ please e-mail unsubscribe at racq.com.au or contact RACQ on 13 19 05.