[c-nsp] Full BGP Feed Convergence Time on ASR 1006 RP2 Setup

[Mark Tinka]

On Tuesday, August 16, 2011 08:02:29 AM Brent Roberts wrote:

> Can anyone provide real world BGP Table convergence times
> on 3 full Peers on an ASR 1006 RP2 for IPV4. Strictly in
> the IP V4 world scheme. Timing reference being  sought
> is for the equivalent of "CLEAR IP BGP ALL" Command.
> Service engine would be a ASR1000-ESP10.

I just brought up an ASR1006 + RP2 + ESP20 + SIP10, peering 
with 3x route reflectors, receiving a full v4/v6/VPNv4 table 
from them, simultaneously.

For v4, the 1st session was done in about 48 seconds, the 
other two were done about 10 seconds earlier than that.

Hope this helps.

Cheers,

Mark.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 836 bytes
Desc: This is a digitally signed message part.
URL: <https://puck.nether.net/pipermail/cisco-nsp/attachments/20111111/c74bef00/attachment.pgp>