[c-nsp] CPU utilization for handling interrupt

Phil Mayers p.mayers at imperial.ac.uk
Wed Oct 5 07:32:15 EDT 2011


On 05/10/11 12:15, Waseem wrote:
> It is a regular internet traffic to port 80, from our customers, which should be CEF switched.

Port 80 traffic to where? Can you show some?

There must be something wrong with the traffic or your config for the 
7600 to be process switching it. You need to give more details instead 
of giving the minimum information in each reply you make.

In your original post, you gave a small config snippet; can you describe 
the topology in more detail? Rather than replacing IP addresses with 
x.x.x.x can you replace them with corresponding private IPs? Or show the 
real config?

I am assuming the traffic is ingressing on the gig interface whose 
config you listed; what is the egress interface?

What is the config for the service-policy you list?

What does:

sh int GiX/X
sh ip int GiX/X
sh tcam int GiX/X acl in ip

...say?


More information about the cisco-nsp mailing list