[c-nsp] Unable to transmit tagged frames over q-in-q tunnel
Gökhan Gümüş
ggumus at gmail.com
Thu Oct 27 12:28:36 EDT 2011
Dear folks,
I have an issue with one of our customer service.
Gi0/5
Gi0/27
Gi5/13 Fa3/13
Customer SW ---------------- Customer Edge Switch-A ----------------PE1
----------MPLS Core --------------PE 2--------------Customer Edge Switch-B
--------------Customer SW
I am using q-in-q tunneling to enable customer traffic. Before, customer
port on Customer SW facing our edge switch was in ACCESS mode and it was
working.
Now they have decided to configure this interface as a TRUNK to transmit
multiple VLANs over the trunk. But they can not.
Currently ports are configured as trunk and customer can only transmit
traffic when they do not tag frames ( native-vlan config )
For note, i am not using " vlan dot1q tag native " command which is also
double-tagging native vlans.
MTU is fine and above 1504 bytes.
Please see our configs on Customer Edge Switch below;
*Customer Edge Switch A;*
A#sh run interface Gigabit Ethernet0/5
Building configuration...
Current configuration : 337 bytes
!
interface GigabitEthernet0/5
switchport access vlan 1106
switchport mode dot1q-tunnel
switchport nonegotiate
load-interval 60
speed 100
duplex full
l2protocol-tunnel cdp
l2protocol-tunnel stp
l2protocol-tunnel vtp
no cdp enable
end
A#sh run interface GigabitEthernet0/27
Building configuration...
Current configuration : 251 bytes
!
interface GigabitEthernet0/27
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,9,1101,1102,1106
switchport mode trunk
switchport nonegotiate
end
---------------------------------------------------------------------------------
*Customer Edge Switch B;*
B#sh run interface fa3/13
Building configuration...
Current configuration : 366 bytes
!
interface FastEthernet3/13
mtu 2000
load-interval 60
switchport
switchport access vlan 1106
switchport mode dot1q-tunnel
switchport nonegotiate
l2protocol-tunnel cdp
l2protocol-tunnel stp
l2protocol-tunnel vtp
no cdp enable
spanning-tree bpdufilter enable
end
B#sh run interface gi5/13
Building configuration...
Current configuration : 298 bytes
!
interface GigabitEthernet5/13
mtu 2000
load-interval 30
speed nonegotiate
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1101,1102,1106
switchport mode trunk
no cdp enable
end
Is there anybody who had such issue before?
Thanks and regards,
Gokhan Gumus
More information about the cisco-nsp
mailing list