[c-nsp] Shaping drops in a policy map - where in CLI output?
Chuck Church
chuckchurch at gmail.com
Fri Sep 16 14:33:39 EDT 2011
Anyone,
Running 12.4 mainline on a 2821, using shaping against an
access list to limit output on a gig Ethernet interface. I'm using
ManageEngine NF analyzer to monitor not just netflow, but also CBWFQ (via
SNMP poll). According to the flow analyzer, it's detecting drops against
these two classes of the output policy below. Is there any way in the CLI
to see the count for total drops? The drop rate is only applicable to the
last 5 minutes. I'm trying to see if the output drops on this policy
explain the output drops listed on the 'sh int' output.
Thanks,
Chuck
Class-map: Prob-customer-38.102 (match-any)
302843 packets, 114113035 bytes
5 minute offered rate 196000 bps, drop rate 0 bps
Match: access-group name customer_38.102
302843 packets, 114113035 bytes
5 minute rate 196000 bps
Traffic Shaping
Target/Average Byte Sustain Excess Interval Increment
Rate Limit bits/int bits/int (ms) (bytes)
768000/768000 4800 19200 19200 25 2400
Adapt Queue Packets Bytes Packets Bytes Shaping
Active Depth Delayed Delayed Active
- 0 302825 114091703 33230 31193614 no
Class-map: Prob-customer-38.102-web (match-any)
640940 packets, 635250900 bytes
5 minute offered rate 1134000 bps, drop rate 0 bps
Match: access-group name customer_38.102_web
640940 packets, 635250900 bytes
5 minute rate 1134000 bps
Traffic Shaping
Target/Average Byte Sustain Excess Interval Increment
Rate Limit bits/int bits/int (ms) (bytes)
3000000/3000000 18750 75000 75000 25 9375
Adapt Queue Packets Bytes Packets Bytes Shaping
Active Depth Delayed Delayed Active
- 27 639611 633304785 315520 416026091 yes
Class-map: class-default (match-any)
3533090 packets, 3039906744 bytes
5 minute offered rate 2842000 bps, drop rate 0 bps
Match: any
More information about the cisco-nsp
mailing list