[c-nsp] Cisco SRE 300 on 2901

[Ranjith R]

Hi All ,

I face an issue with the configuration of ism module on Cisco 2901 router ,
configured as per the documenation , but i am unable to ping the ISM 0/0
interface from the router .
below are the relevant configuration , can someone point out what is wrong
in this.




Current configuration : 179 bytes
!
interface ISM0/0
 ip unnumbered GigabitEthernet0/1
 service-module ip address 10.128.4.7 255.255.255.0
 !Application: Running
 service-module ip default-gateway 10.128.4.6
end

CS2901MPLSVGW.LHR#sh run int gi 0/1
Building configuration...
Current configuration : 98 bytes
!
interface GigabitEthernet0/1
 ip address 10.128.4.6 255.255.255.0
 duplex auto
 speed auto
end

CS2901MPLSVGW.LHR#sh ip route
Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
       E1 - OSPF external type 1, E2 - OSPF external type 2
       i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
       ia - IS-IS inter area, * - candidate default, U - per-user static
route
       o - ODR, P - periodic downloaded static route, H - NHRP, l - LISP
       + - replicated route, % - next hop override
Gateway of last resort is not set
      10.0.0.0/8 is variably subnetted, 3 subnets, 2 masks
C        10.128.4.0/24 is directly connected, GigabitEthernet0/1
L        10.128.4.6/32 is directly connected, GigabitEthernet0/1
S        10.128.4.7/32 is directly connected, ISM0/0
CS2901MPLSVGW.LHR#


Thanks,
Ranjith