[c-nsp] Cisco command to see active session on "cisco WS-C6503-E (R7000)"

[Randy]

--- On Wed, 12/12/12, Dobbins, Roland <rdobbins at arbor.net> wrote:

> From: Dobbins, Roland <rdobbins at arbor.net>
> Subject: Re: [c-nsp] Cisco command to see active session on "cisco WS-C6503-E (R7000)"
> To: "cisco-nsp NSP" <cisco-nsp at puck.nether.net>
> Date: Wednesday, December 12, 2012, 8:35 PM
> 
> On Dec 13, 2012, at 9:40 AM, Andrew Jones wrote:
> 
> > You need netflow enabled on the switch, then enable "ip
> flow ingress"  and "ip flow egress" on the interface
> you are interested in, then perform a "show ip cache flow"
> 
> In addition to all the caveats which render pre-Sup2T/DFC4
> NetFlow on 6500 extremely problematic, one ought never under
> any circumstances to enable both ip flow ingress and ip flow
> egress on the same interface.
> 
> Instead, use one or the other.  But not both.
> 
+1 there! (Perhaps beat-up Cisco; ask for a *note* saying "while both are possible, *doing-both* *is-not-recommended* for reasons *obvious and not-so-obvious*
./Randy