[c-nsp] Moving Routing from 7206VRX to 6509-E

[Randy]

--- On Sun, 12/16/12, Nick Hilliard <nick at foobar.org> wrote:

> From: Nick Hilliard <nick at foobar.org>
> Subject: Re: [c-nsp] Moving Routing from 7206VRX to 6509-E
> To: "An Nguyen" <anguyen at emprisebank.com>
> Cc: "cisco-nsp at puck.nether.net" <cisco-nsp at puck.nether.net>
> Date: Sunday, December 16, 2012, 1:42 PM
> On 16/12/2012 21:32, An Nguyen
> wrote:
> > Would someone please tell me what the commands are to
> setup a Layer 3
> > EtherChannel (LACP preferred) for the 4 ports of the
> 10-GB switch modules
> > on the chassis, and then create several sub-interfaces
> within this
> > EtherChannel?
> 
> interface range ten 1/1-4
>  no switchport
>  channel-group 1 mode active
>  channel-protocol lacp
> 
> interface po1
>  no shutdown
> 
> interface po1.555
>  encapsulation dot1Q 555
>  ip address 192.0.2.1 255.255.255.0
> interface po1.556
>  encapsulation dot1Q 556
>  ip address 192.168.0.1 255.255.255.0
> 
> etc.
> 
> Like others on this channel, I would suggest getting a
> consultant to handle
> this for you.
> 
> Nick

I have to concur. For this platform-migration, it would probably be best to bring in a Consultant.

It also may be worthwhile for your $Employer to consider some form of *service-contract* with Cisco. CCO has a wealth of information (for your own edification). You will need a valid-contract to have access to said info! Google-Foo will only get you so-far.
./Randy