[c-nsp] MPLS TE conver from IOS to IOS-XR

[Oliver Boehmer (oboehmer)]

Hi,


> Since now I can make sure the "Group" command in IOS-XR is the same to the
> "Auto-Template" in IOS,  but my problem is that in the IOS "Auto-Template" I
> can use the below command :
> 
> interface Auto-Template1
> mpls mtu 17916
> tunnel mpls traffic-eng autoroute announce
> tunnel mpls traffic-eng path-option 1 dynamic
> 
> but in the Group, we just have the below command:
> 
> XXXX(config-mpls-te)#auto-tunnel mesh
> XXXX(config-te-auto-mesh)#group 1 ?
>   attribute-set     Attribute-set name of type auto-mesh
>   destination-list  Destination-list (prefix-list) name
>   disable           Disable the mesh group
>   <cr>
> 
> So I am again wondering the group is not the same compared to the Auto-
> Template.
 
you need to configure autoroute-announce and attribute-set, which you in turn reference in the group..  look at the "autoroute announce" in the config I sent.
As far as I know, path-option is always dynamic for auto-tunnel mesh in XR, so no need to configure this.

	oli