[c-nsp] asr9k - 4.1.2 - SH ROUTE isn't responding !!

[Aaron]

Thanks, the bug that the cisco tac told me this was related to didn't
correspond to an smu.  The killing/restarting of the job id for ipv4_rib was
not service affecting (did it during maint window regardless to be safe) and
it fixed it.  The ipv4_rib process was hung at 50% til I did that....and all
ipv4 route show commands were locked.  Oh, the bug that I apparently hit up
against on this was when I used the "longer-prefixes" filter during a show
routes or show bgp activity.  Don't do it.  :|  ....or at least understand
the intricacies of that bug before you do it.  CSCtx98997....i think tac
mentioned that it had something to do with my using longer-prefixes for a
non-existing ip block.

A day later if you can believe it I had another asr9k (4.1.2) start acting
weird.  I was doing some run of the mill interface configurations and
starting getting weird process not responding for 100 seconds
messages....etc.  turns out this was a bug and SMU
disk0:asr9k-p-4.1.2.CSCtx74305-1.0.0  seemed to fix it.

Aaron


-----Original Message-----
From: Jason Lixfeld [mailto:jason at lixfeld.ca] 
Sent: Wednesday, July 11, 2012 7:24 PM
To: Aaron
Subject: Re: [c-nsp] asr9k - 4.1.2 - SH ROUTE isn't responding !!

Check CCO for any mandatory SMUs for 4.1.2.

--

Sent from my mobile device


On 2012-07-11, at 7:31 PM, "Aaron" <aaron1 at gvtc.com> wrote:

> Not sure...
> 
> RP/0/RSP0/CPU0:9k#sh install su
> Wed Jul 11 18:31:20.439 CDT
>  Active Packages:
>    disk0:asr9k-mini-p-4.1.2
>    disk0:asr9k-doc-p-4.1.2
>    disk0:asr9k-k9sec-p-4.1.2
>    disk0:asr9k-mpls-p-4.1.2
>    disk0:asr9k-mgbl-p-4.1.2
> 
> 
> -----Original Message-----
> From: Jason Lixfeld [mailto:jason at lixfeld.ca]
> Sent: Wednesday, July 11, 2012 5:30 PM
> To: Aaron
> Subject: Re: [c-nsp] asr9k - 4.1.2 - SH ROUTE isn't responding !!
> 
> Are you missing any SMUs?
> 
> --
> 
> Sent from my mobile device
> 
> 
> On 2012-07-11, at 6:21 PM, "Aaron" <aaron1 at gvtc.com> wrote:
> 
>> Seen in the log....
>> 
>> RP/0/RSP0/CPU0:Jul 11 16:00:12.038 : sysdb_shared_nc[370]:
>> %SYSDB-SYSDB-6-TIMEOUT_EDM : EDM request for 
>> 'oper/ipv4-rib/gl/vrf/default/afi/IPv4/safi/Unicast/table/default/rou
>> t e-long er/d8b1a422,1d' from 'show_ipv4_rib' (jid 65832, node 
>> 0/RSP0/CPU0). No response from 'ipv4_rib' (jid 1113, node 
>> 0/RSP0/CPU0) within the timeout period (100 seconds)
>> 
>> Cisco tac said do this during maint window...
>> 
>> (admin) process restart 1113 loc 0/rsp0/cpu0
>> 
>> Aaron
>> 
>> 
>> 
>> -----Original Message-----
>> From: cisco-nsp-bounces at puck.nether.net 
>> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Aaron
>> Sent: Wednesday, July 11, 2012 4:28 PM
>> To: cisco-nsp at puck.nether.net
>> Subject: [c-nsp] asr9k - 4.1.2 - SH ROUTE isn't responding !!
>> 
>> RP/0/RSP0/CPU0:9k#sh route
>> 
>> Wed Jul 11 16:27:27.719 CDT
>> 
>> 
>> 
>> Just hangs!!
>> 
>> 
>> 
>> Any ideas ?
>> 
>> 
>> 
>> Aaron
>> 
>> 
>> 
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>> 
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>