[c-nsp] forced up/up on a fiber link

[Tóth András]

Hi,

The "hw-module module <x> simulate link-up" command will probably help
you. It causes all ports on a specified module to be up/up. It might
require "service internal" too.

http://www.cisco.com/en/US/products/ps6017/products_command_reference_chapter09186a0080882963.html#wp1011675

Best regards,
Andras

On Mon, Oct 22, 2012 at 12:35 PM, LM <asturluismi at gmail.com> wrote:
> Hi all,
>
> For copper ethernet port I know there is an option to force up/up with "no
> keepalive"
>
> But, what about a fiber link?
> I have here a 7606 with...
> "Cisco 7600 Series SPA Interface Processor-400 Rev. 2.5"
> "5-port Gigabit Ethernet Shared Port Adapter"
>
>
> "no keepalive" command available under gi3/2/2, which it is a fiber port on
> the related cards I wrote before.
>
> Now, I need to test a config, and I need to force up/up to one port without
> a fiber connected, is it possible? how?
> I am still doing research but, not success so far.
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/