[c-nsp] ME3600x sub-interfaces

[Eric A Louie]

Are sub-interfaces supported on the ME3600x?  Or is there some special formula 
that I need to enable them?

Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 15.2(4)S, 
RELEASE SOFTWARE (fc1)
License Level: AdvancedMetroIPAccess
License Type: Permanent

interface GigabitEthernet0/1
 no switchport
 ip address 192.168.111.2 255.255.255.0
!
interface GigabitEthernet0/2
 description test interface
 switchport access vlan 55
 switchport mode trunk

me3600-2(config)#int g0/1.1
                      ^
% Invalid input detected at '^' marker.

me3600-2(config)#int g0/2.1
                      ^
% Invalid input detected at '^' marker.




 Much appreciated, Eric