[c-nsp] BGP add-path with MPBGP/VPNv4
judy teng
juxiangt at yahoo.com
Thu Dec 5 13:33:48 EST 2013
We used those feature on ASR1k and IOS-XR. It works for VPNv4 as well.
You can enable PIC to PE so that both GWs are available in FIB. Let IGP decides GW instead of using policies.
-Judy
On Thursday, December 5, 2013 10:23 AM, Andrew K. <andrew at vianet.ca> wrote:
I have a VRF configuration with MP-BGP/MPLS.
In vrf A there are two default gateways being advertised to the
route-reflectors.
Half of the PE devices in VRF A need to send traffic out one gateway and
the other half out the other, but the route-reflectors are only sending
one best route to the PE.
Digging up info on add-path, it appears to have very limited support, I
can not find support for it using the feature set navigator for anything
other then the ASR1000, 7600, 3900 and IOS XR.
Is this feature supported by the 7200?
Can it be used in a VPNv4/VRF environment?
Should I just be doing BGP Multipath Load Sharing instead and use a
route-map to set the weight of the default route for each PE device?
Thanks in advance for your time.
Andrew.
_______________________________________________
cisco-nsp mailing list cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
More information about the cisco-nsp
mailing list