[c-nsp] Cisco 6509 LACP
Denis F
fedodv at gmail.com
Mon Feb 11 23:45:36 EST 2013
Hi Mike.
I think the problem is that you trying to connect 10G port to 1G port, it is no LACP ...
On Feb 9, 2013, at 12:25 AM, Mike Glass <MGlass at lccountymt.gov> wrote:
> I hope somebody can help me, I am trying to configure a 6509 as the passive receiver from a Dell Force10 10Ge switch with 2 sfp to 2 gig ports on our 6509 switch, I see LACP is up on both sides but cannot pass traffic, I have only 2 vlans that will carry across the aggregate link from our vmware boxes, this is just a temp until I get a 10ge in our 6509 chassis.
>
> Attached is the config on both sides.
>
> Make sense?
>
> -------------------------------------------------------
> Cisco 6509 Config
> -------------------------------------------------------
>
> interface GigabitEthernet6/7
> switchport
> no ip address
> spanning-tree portfast
> switchport mode trunk
> channel-protocol lacp
> channel-group 1 mode passive
> !
> interface GigabitEthernet6/8
> switchport
> no ip address
> spanning-tree portfast
> switchport mode trunk
> channel-protocol lacp
> channel-group 1 mode passive
>
>
> interface Port-channel1
> description lacp Force10
> switchport
> switchport trunk encapsulation dot1q
> Switchport mode trunk
> no ip address
> logging event link-status
> --------------------------------------------------------
>
> -----------------------------------------------------------------------------------
> show etherchannel detail
> -----------------------------------------------------------------------------------
>
> Channel-group listing:
> -----------------------
>
> Group: 1
> ----------
> Group state = L2
> Ports: 2 Maxports = 16
> Port-channels: 1 Max Port-channels = 16
> Protocol: LACP
> Minimum Links: 0
> Ports in the group:
> -------------------
> Port: Gi6/7
> ------------
>
> Port state = Up Mstr In-Bndl
> Channel group = 1 Mode = Active Gcchange = -
> Port-channel = Po1 GC = - Pseudo port-channel = Po1
> Port index = 0 Load = 0x55 Protocol = LACP
>
> Flags: S - Device is sending Slow LACPDUs F - Device is sending fast LACPDUs.
> A - Device is in active mode. P - Device is in passive mode.
>
> Local information:
> LACP port Admin Oper Port Port
> Port Flags State Priority Key Key Number State
> Gi6/7 SA bndl 32768 0x1 0x1 0x607 0x3D
>
> Partner's information:
>
> Partner Partner LACP Partner Partner Partner Partner Partner
> Port Flags State Port Priority Admin Key Oper Key Port Number Port State
> Gi6/7 FA bndl 32768 0x0 0x1 0xA5 0x3F
>
> Age of the port in the current state: 0d:00h:08m:06s
>
> Port: Gi6/8
> ------------
>
> Port state = Up Mstr In-Bndl
> Channel group = 1 Mode = Active Gcchange = -
> Port-channel = Po1 GC = - Pseudo port-channel = Po1
> Port index = 1 Load = 0xAA Protocol = LACP
>
> Flags: S - Device is sending Slow LACPDUs F - Device is sending fast LACPDUs.
> A - Device is in active mode. P - Device is in passive mode.
>
> Local information:
> LACP port Admin Oper Port Port
> Port Flags State Priority Key Key Number State
> Gi6/8 SA bndl 32768 0x1 0x1 0x608 0x3D
>
> Partner's information:
>
> Partner Partner LACP Partner Partner Partner Partner Partner
> Port Flags State Port Priority Admin Key Oper Key Port Number Port State
> Gi6/8 FA bndl 32768 0x0 0x1 0xA4 0x3F
>
> Age of the port in the current state: 0d:00h:08m:06s
>
> Port-channels in the group:
> ----------------------
>
> Port-channel: Po1 (Primary Aggregator)
>
> ------------
>
> Age of the Port-channel = 1d:01h:24m:05s
> Logical slot/port = 14/1 Number of ports = 2
> Port state = Port-channel Ag-Inuse
> Protocol = LACP
>
> Ports in the Port-channel:
>
> Index Load Port EC state No of bits
> ------+------+------+------------------+-----------
> 0 55 Gi6/7 Active 4
> 1 AA Gi6/8 Active 4
> --------------------------------------------------------------------------------
>
>
>
> ----------------------------------------------------------------------------------------------
> Force 10 Config
> ----------------------------------------------------------------------------------------------
>
> interface TenGigabitEthernet 0/24
> description LAG to VMWARE servers
> no ip address
> !
> port-channel-protocol LACP
> port-channel 2 mode active
> no shutdown
> !
> interface TenGigabitEthernet 0/25
> description LAG to VMWARE servers
> no ip address
> !
> port-channel-protocol LACP
> port-channel 2 mode active
> no shutdown
>
>
> interface TenGigabitEthernet 0/34
> description LAG to Cisco 6905
> no ip address
> !
> port-channel-protocol LACP
> port-channel 1 mode active
> no shutdown
> !
> interface TenGigabitEthernet 0/35
> description LAG to Cisco 6905
> no ip address
> !
> port-channel-protocol LACP
> port-channel 1 mode active
> no shutdown
>
> interface Port-channel 1
> description LAG to Cisco 6905
> no ip address
> switchport
> no shutdown
> !
> interface Port-channel 2
> description LAG to VMWARE Servers
> no ip address
> switchport
> no shutdown
> !
> interface Vlan 1
> !
> interface Vlan 2
> name VMWARE Data VLAN
> no ip address
> tagged Port-channel 1-2
> no shutdown
> !
> interface Vlan 4
> no ip address
> tagged Port-channel 1-2
> no shutdown
> ---------------------------------------------------------
>
>
> --------------------------------------------------------------
> AIS-Prod-1#sh lacp 1
> --------------------------------------------------------------
>
> Port-channel 1 admin up, oper up, mode lacp
> Actor System ID: Priority 32768, Address 0001.e88b.52b8
> Partner System ID: Priority 32768, Address 00d0.0345.8800
> Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
> LACP LAG 1 is an aggregatable link
>
> A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
> E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
> I - Collection enabled, J - Collection disabled, K - Distribution enabled
> L - Distribution disabled, M - Partner Defaulted, N - Partner Non-defaulted,
> O - Receiver is in expired state, P - Receiver is not in expired state
>
> Port Te 0/34 is enabled, LACP is enabled and mode is lacp
> Actor Admin: State ACEHJLMP Key 1 Priority 32768
> Oper: State ACEGIKNP Key 1 Priority 32768
> Partner Admin: State BDFHJLMP Key 0 Priority 0
> Oper: State ADEGIKNP Key 1 Priority 32768
>
> Port Te 0/35 is enabled, LACP is enabled and mode is lacp
> Actor Admin: State ACEHJLMP Key 1 Priority 32768
> Oper: State ACEGIKNP Key 1 Priority 32768
> Partner Admin: State BDFHJLMP Key 0 Priority 0
> Oper: State ADEGIKNP Key 1 Priority 32768
> ---------------------------------------------------------------
>
> ------------------------------------------------------------------
> AIS-Prod-1#sh lacp 2
> ------------------------------------------------------------------
> Port-channel 2 admin up, oper up, mode lacp
> Actor System ID: Priority 32768, Address 0001.e88b.52b8
> Partner System ID: Priority 65535, Address ac16.2d73.1cdc
> Actor Admin Key 2, Oper Key 2, Partner Oper Key 11
> LACP LAG 2 is an aggregatable link
>
> A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
> E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
> I - Collection enabled, J - Collection disabled, K - Distribution enabled
> L - Distribution disabled, M - Partner Defaulted, N - Partner Non-defaulted,
> O - Receiver is in expired state, P - Receiver is not in expired state
>
> Port Te 0/24 is enabled, LACP is enabled and mode is lacp
> Actor Admin: State ACEHJLMP Key 2 Priority 32768
> Oper: State ACEGIKNP Key 2 Priority 32768
> Partner Admin: State BDFHJLMP Key 0 Priority 0
> Oper: State ADEGIKNP Key 11 Priority 255
>
> Port Te 0/25 is enabled, LACP is enabled and mode is lacp
> Actor Admin: State ACEHJLMP Key 2 Priority 32768
> Oper: State ACEGIKNP Key 2 Priority 32768
> Partner Admin: State BDFHJLMP Key 0 Priority 0
> Oper: State ADEGIKNP Key 11 Priority 255
>
>
> Thanks
> Mike
>
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
More information about the cisco-nsp
mailing list