[c-nsp] Cisco 7301 - xconnect on Channel-group

noc at phibee.net noc at phibee.net
Fri Jan 4 04:36:49 EST 2013


Hi

I have a Cisco 7301 with IOS:
(C7301-ADVENTERPRISEK9-M), Version 12.4(15)T1

This cisco is connected to my supplier:

interface Port-channel1
  no ip address


interface GigabitEthernet0/1
  mtu 1600
  no ip address
  duplex auto
  speed auto
  media-type gbic
  negotiation auto
  channel-group 1


On this link, we receive a Vlan: 850

I want sent by EoMPLS this Vlan to a another router,
on other router, without LAG, i use a traditional

interface GigabitEthernet0/1.850
  encapsulation dot1q 850
  no cdp enable
  xconnect xxxxxxxx

But on LAG i don't know the process.

if i create a:
interface GigabitEthernet0/1.850
  channel-group 1
  no cdp enable

i have a error:
7301(config-subif)#encapsulation dot1Q 850
GigabitEthernet0/1 is a member of Port-Channel-1.
The intended configuration is not allowed.

and i don't have xconnect command



if i create a :
interface Port-channel1.850
  encapsulation dot1Q 850

it's good for Vlan but i don't have a xconnect commande on port-channel



what is the solution ?
best regards
Jerome




----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.




More information about the cisco-nsp mailing list