[c-nsp] stp on me3600 on efp's with locally connected older switch

[Aaron]

http://www.cisco.com/en/US/docs/switches/metro/me3600x_3800x/software/release/15.3_1_S/configuration/guide/swevc.html#wp1002521

I think this is what I was looking for ....efp's only support mstp.

Thanks Pshem
Aaron

-----Original Message-----
From: Aaron [mailto:aaron1 at gvtc.com] 
Sent: Thursday, January 24, 2013 2:26 PM
To: 'Pshem Kowalczyk'
Cc: 'cisco-nsp at puck.nether.net'
Subject: RE: [c-nsp] stp on me3600 on efp's with locally connected older switch

Why does " l2protocol peer stp" show up as an option if it's not supported?  Is that one of those things with ios that commands are there but don't work type of thing?   ...anyway, is MST (802.1s) supported on efp's?

Aaron

sv-b-ME3600-test#
sv-b-ME3600-test#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
sv-b-ME3600-test(config)#int g0/22
sv-b-ME3600-test(config-if)#service instance 675 ethernet sv-b-ME3600-test(config-if-srv)#l2protocol peer ?
  cdp   Cisco Discovery Protocol
  dtp   Dynamic Trunking Protocol
  lacp  LACP Protocol
  lldp  Link Layer Discovery Protocol
  pagp  Port Aggregation Protocol
  stp   Spanning Tree Protocol
  udld  UDLD Protocol
  vtp   Vlan Trunking Protocol
  <cr>


-----Original Message-----
From: Pshem Kowalczyk [mailto:pshem.k at gmail.com]
Sent: Thursday, January 24, 2013 1:43 PM
To: Aaron
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] stp on me3600 on efp's with locally connected older switch

Hi,

On 25 January 2013 06:17, Aaron <aaron1 at gvtc.com> wrote:
>
> Need to run stp on me3600 on efp and peer out that interface with 
> older cisco 4500.  Here's what I did..


{cut}

>
> And if anyone has any suggestions about designing loop prevention via 
> me3600's when I'm connecting legacy vlans over vpls via my mpls cloud 
> then fire away.


EFPs don't support STP. You should be able to configure the interface as a regular trunk and then run STP across it.
Peering only applies to CDP, UDLD, LLDP, MSTP, LACP, PAgP, VTP, and DTP:

http://www.cisco.com/en/US/docs/switches/metro/me3600x_3800x/software/release/15.3_1_S/configuration/guide/swevc.html#wp1056594


kind regards
Pshem