[c-nsp] Cisco s0/1/0 T-1 is up but not showing up in route table

[Jay Hennigan]

On 1/30/13 2:52 PM, false wrote:
> The T-1 seems to be up from a Layer-2 perspective. Something is wrong with my routing though. The interface does NOT  show up in the “sh ip route? Output. I would expect to see it as a directly connected interface but it isn't there. The card is in “slot 1” so I’m thinking that may have something to do with but that’s just a hunch. We also have a 9-port switch in the router as well. “Sh diag” looks clean too. Any ideas?

What does "show interface" display for line protocol?

Try:

interface Serial0/1/0
 encapsulation ppp

 service-module t1 timeslots 1-24 speed 64
 service-module t1 framing esf
 service-module t1 linecode b8zs


--
Jay Hennigan - CCIE #7880 - Network Engineering - jay at impulse.net
Impulse Internet Service  -  http://www.impulse.net/
Your local telephone and internet company - 805 884-6323 - WB6RDV