[c-nsp] 7200 - G1 PortChan MTU

[CiscoNSP List]

Both member Ints have the same conf (i.e. both have mtu of 1998) - It's only the portchan that doesnt have an mtu set (So is defaulting to 1500)?




> Date: Sat, 20 Jul 2013 19:42:31 -0700
> From: randy_94108 at yahoo.com
> Subject: Re: [c-nsp] 7200 - G1 PortChan MTU
> To: cisconsp_list at hotmail.com; cisco-nsp at puck.nether.net
> 
> it doesn't matter that the second phyical-member of this port channel is disconnected. It is still a member of this bundle. UP mtu of inactive phy-member to 1998 and then up mtu of port-channel.
> ./Randy
> 
> 
> 
> ----- Original Message -----
> > From: CiscoNSP List <cisconsp_list at hotmail.com>
> > To: "cisco-nsp at puck.nether.net" <cisco-nsp at puck.nether.net>
> > Cc: 
> > Sent: Saturday, July 20, 2013 7:20 PM
> > Subject: [c-nsp] 7200 - G1 PortChan MTU
> > 
> > Hi,
> > 
> > Have a G1, with one active Gig port in a portchan (Second member is currently 
> > disconnected, but is also a Gig port on the G1) - No other ports are configured 
> > as member ports.
> > 
> > Gi0/1 (Active member) has an mtu of 1998 - Portchan doesnt have an mtu 
> > configured (So is defaulting to 1500)
> > 
> > Attempting to change the mtu on the portchan, I get the following:
> > 
> > (config)#interface Port-channel1(config-if)#mtu 1998               % At least 
> > one member of the channel group 1 is not a 2FE port adapter
> > 
> > Any suggestions why this is happening? 
> > 
> > And I assume the only way to resolve this is to default the member ints, re-add 
> > them to the portchan and then change the mtu on the portchan?
> > 
> > Cheers.
> > 
> > 
> >                           
> > _______________________________________________
> > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-nsp
> > archive at http://puck.nether.net/pipermail/cisco-nsp/
> >