[c-nsp] OSPF question

[Robert]

Hi,

I'm a little bit confused while configuring a CAT6509 switch with OSPF.
So far, I used on the c7206-VXR platform the following config:

!
router ospf 12345
 router-id 192.168.100.232
 redistribute connected subnets
 redistribute static
 passive-interface default
 no passive-interface GigabitEthernet0/1.50
 network 192.168.100.0 0.0.15.255 area 0
!
...
...
!
interface GigabitEthernet0/1.50
 encapsulation dot1Q 556
 ip address 192.168.100.197 255.255.255.252
 no ip redirects
 no ip proxy-arp
 ip ospf 12345 area 0
 ipv6 address 2001:5DD:50::1/126
 ipv6 nd ra suppress
 ipv6 ospf 12345 area 0
!

Now, with IOS "s72033-advipservicesk9_wan-mz.122-33.SXJ3" the statement
"ip ospf <process-ID> area 0" is missing.

!
interface GigabitEthernet4/21
 switchport
 switchport trunk encapsulation dot1q
 switchport mode trunk
 switchport trunk allowed vlan 50
 no cdp enable
!
...
...
!
interface Vlan50
 ip address 192.168.100.197 255.255.255.252
 no ip redirects
 no ip proxy-arp
 ipv6 address x:x:x:x::y/126
 ipv6 nd ra suppress
 ipv6 ospf 12345 area 0
!

The "ip ospf area 0" command is unrecognized :-( Any ideas?



Regards,

Robert