[c-nsp] 4500-X VSS %EC-5-CANNOT_BUNDLE2

[CiscoNSP List]

Hi,

Just an update to this - If I remove "switch virtual link " from the portchans, and then re-apply them to the tenGig ints, the portchan comes up?

Portchan conf (That fails):  (Hotmail will probably screw the formatting):

interface Port-channel5
 switchport
 switchport mode trunk
 switchport nonegotiate
 switch virtual link 1

And Int conf:

interface TenGigabitEthernet1/16 switchport mode trunk
switchport nonegotiate
no lldp transmit
no lldp receive
no cdp enable
channel-group 5 mode on
service-policy output VSL-Queuing-Policy




> Subject: Re: [c-nsp] 4500-X VSS  %EC-5-CANNOT_BUNDLE2
> To: cisconsp_list at hotmail.com; cisco-nsp-bounces at puck.nether.net; cisco-nsp at puck.nether.net
> From: ed at edgeoc.net
> Date: Fri, 8 Mar 2013 06:12:02 +0000
> 
> 'sho run in te1/16'
> 
> Sounds like you have dtp on it currently and it doesn't like that... Try defaulting the interface first?
> 
> 
> ------Original Message------
> From: CiscoNSP List
> Sender: cisco-nsp-bounces at puck.nether.net
> To: cisco-nsp at puck.nether.net
> Subject: [c-nsp] 4500-X VSS  %EC-5-CANNOT_BUNDLE2
> Sent: Mar 7, 2013 9:39 PM
> 
> 
> 
> Hi Guys,
> 
> Following this guide: https://supportforums.cisco.com/docs/DOC-29472 and when trying to add the physical Int to the portchan, I get:
> 
> %EC-5-CANNOT_BUNDLE2: TE1/16 is not compatible with PO5 and will be suspended (trunk mode of TE1/16 is dynamic, P05 is trunk)
> 
> Config has been entered as per the above doc - Any suggestions as to why this is happening?
> 
> Both switches are running: 
> cat4500-e-ios-promupgrade-150-1r-SG7cat4500e-universalk9.SPA.03.04.00.SG.151-2.SG.bin
> 
> 
> Cheers.
> 
>  		 	   		  
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>