[c-nsp] Rancid causing reload SUP2T 12.2.50-SY3

heasley heas at shrubbery.net
Tue Mar 26 17:29:16 EDT 2013


Tue, Mar 26, 2013 at 01:24:52PM -0600, Tammy A Wisdom:
> It happened as rancid logged out I believe. 

Assuming that rancid is not complaining about the collection failing, you
are probably correct.  If you use AAA accounting or command authorization,
you might try disabling that.  Its really the only thing extraordinary that
might occur at logout.

If its caused by residue from some command, you can poke the fire; run the
commands that rancid would run, removing one at time until it stops crashing.
That would be:
clogin -t 90 -c 'show version;show redundancy secondary;show idprom backplane;show install active;show env all;show rsp chassis-info;show gsr chassis;show diag chassis-info;show boot;show bootvar;show variables boot;show flash;dir /all nvram:;dir /all bootflash:;dir /all slot0:;dir /all disk0:;dir /all slot1:;dir /all disk1:;dir /all slot2:;dir /all disk2:;dir /all harddisk:;dir /all harddiska:;dir /all harddiskb:;dir /all sup-bootdisk:;dir /all sup-bootflash:;dir /all sup-microcode:;dir /all slavenvram:;dir /all slavebootflash:;dir /all slaveslot0:;dir /all slavedisk0:;dir /all slaveslot1:;dir /all slavedisk1:;dir /all slaveslot2:;dir /all slavedisk2:;dir /all slavesup-bootflash:;dir /all sec-nvram:;dir /all sec-bootflash:;dir /all sec-slot0:;dir /all sec-disk0:;dir /all sec-slot1:;dir /all sec-disk1:;dir /all sec-slot2:;dir /all sec-disk2:;show controllers;show controllers cbus;show diagbus;show diag;show capture;show module;show spe version;show c7200;show inventory raw;show vtp status;show vlan;show vlan-switch;show debug;show shun;more system:running-config;show running-config view full;show running-config;write term' hostname



More information about the cisco-nsp mailing list