[c-nsp] Rancid causing reload SUP2T 12.2.50-SY3

Tammy A Wisdom tammy-lists at wiztech.biz
Tue Mar 26 19:46:43 EDT 2013


Yea I don't recall if we did that or not. We changed to juniper afterwards :)


Sent from my iPhone

On Mar 26, 2013, at 15:29, heasley <heas at shrubbery.net> wrote:

> Tue, Mar 26, 2013 at 01:24:52PM -0600, Tammy A Wisdom:
>> It happened as rancid logged out I believe.
> 
> Assuming that rancid is not complaining about the collection failing, you
> are probably correct.  If you use AAA accounting or command authorization,
> you might try disabling that.  Its really the only thing extraordinary that
> might occur at logout.
> 
> If its caused by residue from some command, you can poke the fire; run the
> commands that rancid would run, removing one at time until it stops crashing.
> That would be:
> clogin -t 90 -c 'show version;show redundancy secondary;show idprom backplane;show install active;show env all;show rsp chassis-info;show gsr chassis;show diag chassis-info;show boot;show bootvar;show variables boot;show flash;dir /all nvram:;dir /all bootflash:;dir /all slot0:;dir /all disk0:;dir /all slot1:;dir /all disk1:;dir /all slot2:;dir /all disk2:;dir /all harddisk:;dir /all harddiska:;dir /all harddiskb:;dir /all sup-bootdisk:;dir /all sup-bootflash:;dir /all sup-microcode:;dir /all slavenvram:;dir /all slavebootflash:;dir /all slaveslot0:;dir /all slavedisk0:;dir /all slaveslot1:;dir /all slavedisk1:;dir /all slaveslot2:;dir /all slavedisk2:;dir /all slavesup-bootflash:;dir /all sec-nvram:;dir /all sec-bootflash:;dir /all sec-slot0:;dir /all sec-disk0:;dir /all sec-slot1:;dir /all sec-disk1:;dir /all sec-slot2:;dir /all sec-disk2:;show controllers;show controllers cbus;show diagbus;show diag;show capture;show module;show spe version;show c7200;show inventory raw;show vtp status;show vlan;show vlan-switch;show debug;show shun;more system:running-config;show running-config view full;show running-config;write term' hostname



More information about the cisco-nsp mailing list