[c-nsp] nexus 5500 + fcoe + citrix ven 6.1
Ryan West
rwest at zyedge.com
Tue May 28 08:12:38 EDT 2013
You are not fully logged into the fabric. Did you create the necessary FCoE QoS policy?
Sent from handheld.
On May 28, 2013, at 8:06 AM, "Piotr" <piotr.1234 at interia.pl> wrote:
> Hi,
>
> I'm new in nexus world, i just test some switches and i have problem:
>
> There is one switch 5548 with version 6.0(2)N1(2a). I try to make fcoe conenction between xenserver 6.1 (port 1/25) and linux fcoe target ( centos, port 1/26).
>
> In both servers i have card: Cisco Systems Inc VIC FCoE HBA (rev a2), on centos (target side) all looks good but from xenserver i don't see any traffic. In xencenter i see the cisco card connected but when try to discover new storage, xencenter don't find anything.
>
>
> thanks for any help or clue
>
> regards,
> Piotr
>
>
> my config:
>
> vlan 11
> fcoe vsan 11
>
> vsan database
> vsan 11
>
> interface vfc2
> bind interface Ethernet1/25
> no shutdown
>
> interface vfc26
> bind interface Ethernet1/26
> no shutdown
>
> vsan database
> vsan 11 interface vfc2
> vsan 11 interface vfc26
>
>
> interface Ethernet1/25
> switchport mode trunk
> spanning-tree port type edge trunk
>
> interface Ethernet1/26
> switchport mode trunk
> spanning-tree port type edge trunk
>
>
>
> outputs:
>
> show lldp neighbors
> Capability codes:
> (R) Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device
> (W) WLAN Access Point, (P) Repeater, (S) Station, (O) Other
> Device ID Local Intf Hold-time Capability Port ID
> 0018.8b9c.cfe6 mgmt0 120 g21
> nexus-2 Eth1/1 120 B Eth1/1
> nexus-2 Eth1/2 120 B Eth1/2
> nexus-2 Eth1/3 120 B Eth1/3
> nexus-2 Eth1/5 120 B Eth1/5
> nexus-test2 Eth1/7 120 B Eth1/1
> b0fa.eb72.7c06 Eth1/25 120 b0fa.eb72.7c0a
> b0fa.eb72.7f3e Eth1/26 120 b0fa.eb72.7f42
>
>
>
> show fcoe database
>
> -------------------------------------------------------------------------------
> INTERFACE FCID PORT NAME MAC ADDRESS
> -------------------------------------------------------------------------------
> vfc26 0x6a0000 20:00:b0:fa:eb:72:7f:41 b0:fa:eb:72:7f:41
>
> Total number of flogi count from FCoE devices = 1.
>
> VE Ports:
> -------------------------------------------------------------------------------
> INTERFACE MAC ADDRESS VSAN
> -------------------------------------------------------------------------------
> vfc1 54:7f:ee:8e:ad:0c 2
>
>
>
>
>
> port 26, only target is ok:
>
> show flogi database
> --------------------------------------------------------------------------------
> INTERFACE VSAN FCID PORT NAME NODE NAME
> --------------------------------------------------------------------------------
> vfc26 2 0x6a0000 20:00:b0:fa:eb:72:7f:41 10:00:b0:fa:eb:72:7f:41
>
>
> but from xencenter side there is no traffic:
>
> show interface vfc 2
> vfc2 is trunking
> Bound interface is Ethernet1/25
> Hardware is Ethernet
> Port WWN is 20:01:54:7f:ee:8e:ac:7f
> Admin port mode is F, trunk mode is on
> snmp link state traps are enabled
> Port mode is TF
> Port vsan is 11
> Trunk vsans (admin allowed and active) (1-2,11)
> Trunk vsans (up) ()
> Trunk vsans (isolated) ()
> Trunk vsans (initializing) (1-2,11)
> 1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
> 1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
> 0 frames input, 0 bytes
> 0 discards, 0 errors
> 0 frames output, 0 bytes
> 0 discards, 0 errors
> last clearing of "show interface" counters Sun Feb 21 11:15:15 2010
>
> Interface last changed at Sun Feb 21 11:15:15 2010
>
>
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
More information about the cisco-nsp
mailing list