[c-nsp] IP nat translation

[Panocisco77]

Randy
How do I change the dynamic time out ?

Renelson

> On Sep 29, 2013, at 4:23 PM, Randy <randy_94108 at yahoo.com> wrote:
> 
> you are performing PAT and dynamic translations timout after a period of non-use.
> IIRC on router IOS the defaults are:
> 24 hrs for tcp unless a rst or fin is seen
> non-dns udp is 5 mins; dns: 1 min
> Only static entries remain indefinitely - as long as it is present in config.
> ./Randy
> 
> 
> 
> 
> 
> 
>> ________________________________
>> From: Renelson Panosky <panocisco77 at gmail.com>
>> To: cisco-nsp at puck.nether.net 
>> Sent: Sunday, September 29, 2013 12:17 PM
>> Subject: [c-nsp] IP nat translation
>> 
>> 
>> How do i restore IP nat and the IP NAT translation table ? they are not
>> showing on my IP nat translation..
>> 
>> here are my configuraation..
>> ip nat inside source list 1 interface GigabitEthernet0/1 overload
>> 
>> route-map NAT_1 permit 1
>> match ip address 1
>> match interface GigabitEthernet0/1
>> !
>> access-list 1 permit 10.10.0.0 0.0.255.255
>> 
>> sho ip nat translation
>> Pro Inside global      Inside local       Outside local      Outside global
>> udp 164.XX.XX.XX:12134 10.XX.XX.X:12134   10.XX.XX.XX:12134
>> 10.XXX.XX.XX:12134
>> 
>> the translation would show on the table for sometimes and dispear..
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>> 
>> 
>>