[c-nsp] xconnect not working..

[Raheel Muhammad]

Hi gents,

I am facing issues in xconnect, encapsulation is l2tp and xconnect is
showing up, but the traffic is not passing, any suggestions? configuration
is below:

interface GigabitEthernet9/8.2521
 encapsulation dot1Q 2521
 xconnect 10.11.52.6 200 encapsulation l2tpv3 pw-class 200
end

pseudowire-class 2521
 encapsulation l2tpv3
 ip local interface Loopback0
!


#sh xconnect all
Legend:    XC ST=Xconnect State  S1=Segment1 State  S2=Segment2 State
  UP=Up       DN=Down            AD=Admin Down      IA=Inactive
  SB=Standby  HS=Hot Standby     RV=Recovering      NH=No Hardware

XC ST  Segment 1                         S1 Segment 2
  S2
------+---------------------------------+--+---------------------------------+--
UP     ac   PO1/2/0(PPP)                 UP mpls 10.11.52.1:400
  UP
UP     ac   Gi9/8.2521:200(Eth VLAN)    UP l2tp 10.11.52.6:2521
 UP


PE-II

interface GigabitEthernet3/0/2.2521
 encapsulation dot1Q 2521
 xconnect 213.132.242.208 200 encapsulation l2tpv3 pw-class 200
end


#sh xconnect all
Legend:    XC ST=Xconnect State  S1=Segment1 State  S2=Segment2 State
  UP=Up       DN=Down            AD=Admin Down      IA=Inactive
  SB=Standby  HS=Hot Standby     RV=Recovering      NH=No Hardware

XC ST  Segment 1                         S1 Segment 2
  S2
------+---------------------------------+--+---------------------------------+--
UP pri   ac Gi3/0/2.2521:200(Eth VLAN)  UP l2tp 213.132.242.208:200
 UP

pseudowire-class 200
 encapsulation l2tpv3
 ip local interface Loopback0

THanks
Raheel