[c-nsp] uBR7246VXR - etherchannel outbound load balancing ?

[Aaron]

As you can see I have a channel group with (2) underlying member ints.  I
have inbound loadbalancing working (which I don't believe has anything to do
with this cmts, but rather they 9k sending they traffic to the cmts). but my
question is why isn't the cmts load balancing outbound traffic over both of
its links?  Would seem to have something to do with the etherchannel load
balancing hash mechanism. like src-mac, src-dest-ip, etc, etc. but I don't
see any of those load balance tweaks as options in the cmts.. Is it possibly
?  if so, how?

 

G0/2 below shows nothing for output... 30 second output rate 0 bits/sec, 0
packets/sec

 

cmts0#sh int port- 1 | in Member

        Member 0 : GigabitEthernet0/1 , Full-duplex, 1000Mb/s

        Member 1 : GigabitEthernet0/2 , Full-duplex, 1000Mb/s

 

cmts0#sh int g0/1 | in 30 sec

  30 second input rate 213916000 bits/sec, 23037 packets/sec

  30 second output rate 48344000 bits/sec, 22945 packets/sec

 

cmts0#sh int g0/2 | in 30 sec

  30 second input rate 209965000 bits/sec, 21816 packets/sec

  30 second output rate 0 bits/sec, 0 packets/sec

 

cmts0#sh ver | in 7246

cisco uBR7246VXR (NPE-G2) processor (revision A) with 1966080K/65536K bytes
of memory.

 

cmts0#sh ver | in IOS

Cisco IOS Software, 7200 Software (UBR7200P-JK9SU2-M), Version 12.2(33)SCD7,
RELEASE SOFTWARE (fc2)

BOOTLDR: Cisco IOS Software, 7200 Software (UBR7200P-KBOOT-M), Version
12.2(33)SCD7, RELEASE SOFTWARE (fc2)

 

Aaron