[c-nsp] BVI on ME3600?

[Adam Vitkovsky]

Hi folks,
Is there a support for bvi or routed interface in bridge-domain or vfi on
me3600. 

I'd like to terminate couple of p2p xconnects in a common bridge-domain/vfi
along with a vlan interface with vrf designation and ip address and I can't
get it working. 


l2 vfi corporate-inet manual 
 vpn id 2
 bridge-domain 4001
 neighbor 10.105.1.5 1412171450 encapsulation mpls
!
!
interface Vlan4001
 mtu 9000
 vrf forwarding inet
 ip address 192.168.50.4 255.255.255.0
 xconnect vfi corporate-inet


sh l2 vfi
VFI name: corporate-inet, state: down, type: multipoint, signaling: LDP
  VPN ID: 2
  Bridge-Domain 4001 attachment circuits:
    Vlan4001  
  Pseudo-port interface: pseudowire100009
  Interface          Peer Address     VC ID        S
  pseudowire100010   10.105.1.5       1412171450   Y


sh mpls l2 vc 1412171450 det 
Local interface: VFI corporate-inet vfi down
  Interworking type is Ethernet
  Destination address: 10.105.1.5, VC ID: 1412171450, VC status: down
    Last error: Local access circuit is not ready for label advertise
    Output interface: none, imposed label stack {}
    Preferred path: not configured  
    Default path: no route
    No adjacency
  Create time: 00:06:34, last status change time: 4w3d
    Last label FSM state change time: 00:06:34
  Signaling protocol: LDP, peer 10.105.1.5:0 up
    Targeted Hello: 10.105.1.6(LDP Id) -> 10.105.1.5, LDP is UP
    Graceful restart: configured and enabled
    Non stop routing: not configured and not enabled
    Status TLV support (local/remote)   : enabled/supported
      LDP route watch                   : enabled
      Label/status state machine        : remote ready, LndRru
      Last local dataplane   status rcvd: No fault
      Last BFD dataplane     status rcvd: Not sent
      Last BFD peer monitor  status rcvd: No fault
      Last local AC  circuit status rcvd: DOWN(hard-down, not-ready)
      Last local AC  circuit status sent: No fault
      Last local PW i/f circ status rcvd: No fault
      Last local LDP TLV     status sent: No status
      Last remote LDP TLV    status rcvd: No fault
      Last remote LDP ADJ    status rcvd: No fault
    MPLS VC labels: local unassigned, remote 24 
    Group ID: local unknown, remote 0
    MTU: local unknown, remote 9000
    Remote interface description: [inet] backhaul for corporate inet common
subnet
  Sequencing: receive disabled, send disabled
  Control Word: Off (configured: autosense)
  Dataplane:
    SSM segment/switch IDs: 0/0 (used), PWID: 7
  VC statistics:
    transit packet totals: receive 0, send 0
    transit byte totals:   receive 0, send 0
    transit packet drops:  receive 0, seq error 0, send 0


thanks

adam