[c-nsp] DFC3C-XL refuses to operate in XL mode
Jiri Prochazka
jiri.prochazka at superhosting.cz
Wed Jul 30 09:56:57 EDT 2014
Lukas,
the other cards do not have any negative impact on the PFC mode of the
whole chassis. As soon as I remove this one particular DFC (module 4, SN
SAL1406AMHG) the chassis boots to XL module, with all other cards
operating in 3CXL.
To keep thigs simple, I have removed all cards except the module 4
(6704-10GE with the weird DFC3CXL) and the module 6 (RS720-3CXL).
ROMMON should be fine.
7606S-lab#show module version
Mod Port Model Serial # Versions
---- ---- ------------------ -----------
-------------------------------------
4 4 WS-X6704-10GE SAL16020J6H Hw : 1.5
Fw : 12.2(18r)S1
Sw : 12.2(33)SRE10
Sw1: 8.7(0.22)FW292
WS-F6700-DFC3CXL SAL1406AMHG Hw : 1.4
6 2 RSP720-3CXL-GE SAL1538QMQX Hw : 5.9
Fw : 12.2(33r)SRE
Sw : 12.2(33)SRE10
Sw1: 8.7(0.22)FW292
7600-MSFC4 SAL1538AW19 Hw : 1.5
Fw : 12.2(33r)SRE
Sw : 12.2(33)SRE10
7600-PFC3CXL SAL153813DT Hw : 1.0
Again, after a boot, this appears in the log.
*Feb 25 05:59:37.027: %OIR-SP-6-DOWNGRADE_EARL: Module 6 PFC installed
is not identical to system PFC and will perform at current system
operating mode.
I am sure the problem is with the DFC module itself (ok, with two
modules, which is even stranger. The second module is not mounted to any
card now, lying on the desk). The question is, what kind of problem? It
just operates as it's DFC3, not DFC3CXL.
Thanks,
Jiri
Dne 30.7.2014 15:46, Lukas Tribus napsal(a):
> Hi,
>
>
>> 7606S-lab#show platform hardware pfc mode
>> PFC operating mode : PFC3C
>
> Can you post a show module when the linecards
> are actually enabled and the chassis is in 3C mode?
>
> Did you upgrade ROMMON on all those linecards to
> 12.2(18r)S1?
>
>
> Lukas
>
>
>
--
Jiri Prochazka
network administrator (AS39392)
SuperNetwork s.r.o.
m: +420 777 87 37 67
w: http://www.superhosting.cz
e: jiri.prochazka at superhosting.cz
More information about the cisco-nsp
mailing list