[c-nsp] Cisco ASR901 and Tunnels

[Pete Lumbis]

I can't find info that says they are supported, but I'd assume not.


On Mon, May 12, 2014 at 5:38 PM, Ivan <cisco-nsp at itpro.co.nz> wrote:

> Thanks Pete. Do you know if any of the other tunnelling modes are
> supported?
>
>   ipip    IP over IP encapsulation
>   ipsec   IPSec tunnel encapsulation
>   ipv6    Generic packet tunneling in IPv6
>   ipv6ip  IPv6 over IP encapsulation
>
> Thanks
>
> Ivan
>
> > GRE is not supported on the ASR901.
> >
> >
> > On Mon, May 12, 2014 at 5:59 AM, Ivan <cisco-nsp at itpro.co.nz> wrote:
> >
> >> I have some Cisco ASR901s and would like to have a layer 2 or layer 3
> >> tunnel between them over a layer 3 network.
> >>
> >> I have configured GRE and tunnel is up and it is possible to ping the
> >> remote ends.  All looks good from the control plane side but I am not
> >> having success with traffic being forwarded.
> >>
> >> Although I have been able to configure this as far as I can tell there
> >> is
> >> nothing in the doco for this.  I am thinking it maybe one of those "you
> >> can configure but not supported" things.
> >>
> >> Can anyone confirm if GRE tunnels or similar are actually supported?
> >>
> >> Hardware: ASR 901
> >> Software: 15.4(1)S1
> >> License Level: IPBase
> >>
> >> Thanks
> >>
> >> Ivan
> >>
> >> _______________________________________________
> >> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> >> https://puck.nether.net/mailman/listinfo/cisco-nsp
> >> archive at http://puck.nether.net/pipermail/cisco-nsp/
> >>
> >
>
>
>