[c-nsp] ipv6 cmts (uBR7246VXR) and arris cable modem TM602G

[JF Tremblay]

On Oct 16, 2014, at 12:07 PM, Aaron <aaron1 at gvtc.com> wrote:

> SW_REV: 6.4.49T
> MODEL: TM602G  
> Firmware Name: TS060449_102513_MODEL_6_TELNET_ON 
> Firmware Build Time:  Fri Oct 25 15:06:46 EDT 2013 

That version should support it, imo. You even have telnet access, apparently. 

Try running the CM in IPv6 first to see if it comes up properly (cable ip-init ipv6 under the cable interface). Some instructions are detailed there (but I guess you’ve seen this): http://www.cisco.com/c/en/us/td/docs/cable/cmts/config_guide/b_CMTS_Router_Layer3_BundleInterface/b_CMTS_Router_Layer3_BundleInterface_chapter_01.html

There’s a MDD override MIB that has to be off (at “honor-mdd” actually) on the CM for this to work. Otherwise, posting your bundle config might help, but debugging IPv6 on a CMTS isn’t a small feat. 

For reference, this Live presentation isn’t bad either (it does have a focus on CNR however): https://www.ciscolive.com/online/connect/sessionDetail.ww?SESSION_ID=7934

JF