[c-nsp] BGP doesn't advertise prefixes

[Scott Granados]

It could be a bug but most likely a configuration issue.  The bugs on the 65xx platform are normally more like the supervisor will crash when the BGP table counter reaches a certain threshold or similar to that not just the lack of advertisement to a single peer.  It’s possible but if you could post the relevant portions of your on fig that would probably yield better results.

Thanks
 

On Apr 28, 2015, at 5:59 AM, Samol <molasian at gmail.com> wrote:

> Hi All,
> 
> Weird issue of BGP running on:
> 
> Cisco IOS Software, s72033_rp Software (s72033_rp-IPSERVICESK9_WAN-M),
> Version 12.2(33)SXJ2, RELEASE SOFTWARE (fc4)
> 
> cisco WS-C6503-E (R7000) processor (revision 1.3) with 983008K/65536K bytes
> of memory.
> 
> We did the configuration correctly and we applied on different peers. other
> peers are advertising routes, but on peer is not. using "sh ip bgp
> route-map X" , we can see that route-map is matching what we want, however,
> " show ip bgp neighbors 1.2.3.4 advertised-routes " gives only one prefix
> advertise out, and sometimes it doesn't advertise out either.
> 
> Is there any known bug on this or anything else should I check ?
> 
> Regards.
> 
> -- 
> Samol Khoeurn
> (855) 077 55 64 02 / (855) 070 52 53 46
> Network Engineer
> Cisco: CCNA/CCNP SP/CCIP/
> Juniper: JNCIA/JTNOC/JNCIS-ENT,SP,SEC/JNCIP-ENT,SP
> Blog: http://thesaltedegg.net
> www.linkedin.com/in/samolkhoeurn
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/