[c-nsp] VPLS BGP Signaling

[Mohammad Khalil]

Hi allI have two CSR1000v boxes which am trying to establish several VPLS combinations for connectivity between two switchesAll combinations worked perfectly except for BGP signaling (all the previous setups depend on LDP as a signaling protocol)
CSR1,CSR2l2vpn vfi context VFIB vpn id 105 autodiscovery bgp signaling bgp  ve id 105  ve range 55  route-target export 1:1  route-target import 1:1
bridge-domain 105 member GigabitEthernet2 service-instance 105 member vfi VFIB
interface GigabitEthernet2 no ip address negotiation auto service instance 105 ethernet  encapsulation dot1q 105
ASR1#sh xconnect allLegend:    XC ST=Xconnect State  S1=Segment1 State  S2=Segment2 State  UP=Up       DN=Down            AD=Admin Down      IA=Inactive  SB=Standby  HS=Hot Standby     RV=Recovering      NH=No Hardware
XC ST  Segment 1                         S1 Segment 2                         S2------+---------------------------------+--+---------------------------------+---- pri  vfi VFIB                         UP unkn Invalid Segment              --UP pri   bd 105                          UP  vfi VFIB                         UP
ASR1#show bgp l2vpn vpls allBGP table version is 5, local router ID is 1.1.1.1Status codes: s suppressed, d damped, h history, * valid, > best, i - internal,              r RIB-failure, S Stale, m multipath, b backup-path, f RT-Filter,              x best-external, a additional-path, c RIB-compressed,Origin codes: i - IGP, e - EGP, ? - incompleteRPKI validation codes: V valid, I invalid, N Not found
     Network          Next Hop            Metric LocPrf Weight PathRoute Distinguisher: 1:105 * i 1:105:VEID-105:Blk-55/136                       3.3.3.3                  0    100      0 ? *>                   0.0.0.0                            32768 ?
No ping between the two hosts 
ASR1#sh run | sec router bgprouter bgp 1 bgp log-neighbor-changes no bgp default ipv4-unicast neighbor 3.3.3.3 remote-as 1 neighbor 3.3.3.3 update-source Loopback0 ! address-family ipv4 exit-address-family ! address-family l2vpn vpls  neighbor 3.3.3.3 activate  neighbor 3.3.3.3 send-community both  neighbor 3.3.3.3 suppress-signaling-protocol ldp exit-address-family
Any ideas?
Thanks
BR,Mohammad