[c-nsp] Catalyst 6500 TCAM Allocation Adjustment with VSS

[Andrea Galassi]

I tried two days ago.
I reloaded the standby switch, then i forced a switchover and reloaded 
the other switch.

The first switch became active, but maintained the old tcam values.
If you reboot one switch at a time, tcam setting remain inaltered.

In my situation it needed a full reboot to adjust tcam settings.

Il 7/15/2015 7:32 PM, Andrea Galassi ha scritto:
> Hi all,
>
> I need to adjust the TCAM memory allocation on a Catalyst 6500 in VSS
> mode. The two supervisors are VS-S720-10G-3CXL and the IOS is the 
> version 15.1(2)SY4a.
>
> From what I understand, after giving the command "mls cef maximum-routes
> ip xxx" is necessary to reboot the switch.
>
> I wondered if it were possible, as they are in VSS mode, restart a
> switch at a time.
>
> Thanks in advance
> Andrea
>
>
>
>
>
>
>
> ----------------------------------------------------------------
> Imagination is more important than knowledge. Knowledge is limited 
> while imagination embraces the entire world.
> ----------------------------------------------------------------
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/