[c-nsp] Port Channel Speed

sathish kumar Ippani sathish.kumar.ippani at gmail.com
Mon May 11 11:57:13 EDT 2015


Hi All,

First thanks to everyone.

WE have a port channel on NX 5548 connected to Cisco FI. There are two 10Gb
interface are bounded to it.

Here when we checked the sh int portchannel 1. it shows following output.

port-channel1 is up
  Hardware: Port-Channel, address: 002a.6a4d.0f68 (bia 002a.6a4d.0f68)
  MTU 1500 bytes, BW 20000000 Kbit, DLY 10 usec
  reliability 255/255, txload 5/255, rxload 13/255
  Encapsulation ARPA
  Port mode is trunk
  full-duplex, 10 Gb/s
  Input flow-control is off, output flow-control is off
  Switchport monitor is off
  EtherType is 0x8100
  Members in this channel: Eth1/1, Eth1/2
  1 interface resets
  30 seconds input rate 611861136 bits/sec, 64564 packets/sec
  30 seconds output rate 403292840 bits/sec, 45537 packets/sec


Would like to know the two different speeds shows in the output. I,e 20Gb
and 10Gb


-- 
With Regards,

Sathish Ippani
9177166040


More information about the cisco-nsp mailing list