[c-nsp] Logs are empty

[Michael Malitsky]

sh run all produces the same output: " logging buffered 128000".  I thought debug was usually default...
Sh log says " Buffer logging:  level debugging"
I did try logging buff info, no difference.  Until those 13 messages showed up, I thought logging was turned off completely, and "logging on" wasn't helping.

Sincerely,
Michael

-----Original Message-----
From: Randy [mailto:randy_94108 at yahoo.com] 
Sent: Tuesday, May 12, 2015 1:56 PM
To: Michael Malitsky; Chuck Church
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] Logs are empty

Curious abut the default severity level for "logging buffered"? Sh run all should list. You could also try setting to logging buff info

Regards,
./Randy



----- Original Message -----
From: Michael Malitsky <malitsky at netabn.com>
To: Chuck Church <chuckchurch at gmail.com>
Cc: "cisco-nsp at puck.nether.net" <cisco-nsp at puck.nether.net>
Sent: Tuesday, May 12, 2015 11:49 AM
Subject: Re: [c-nsp] Logs are empty

Correct, no syslog host configured yet.

Sincerely,
Michael


Chuck Church <chuckchurch at gmail.com> wrote:

Plus there were thousands of syslogs that were dropped.  I'm assuming
because no hosts look to be configured?  Not sure they that's not getting to
the buffer though.

Chuck

-----Original Message-----
From: cisco-nsp [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of
Michael Malitsky
Sent: Tuesday, May 12, 2015 2:27 PM
To: Lukas Tribus; cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] Logs are empty

True.  However, "logging monitor" plus "terminal monitor" change absolutely
nothing.

I do expect more messages in the buffer, especially after having debugs
turned on, for traffic that I know is transiting the router.  At least
acknowledgements of configuration changes.  Something, besides messages
incident to the router booting up.  BTW, these 13 did not show up until 3-4
hours after boot.
Thanks

Sincerely,
Michael

-----Original Message-----
From: Lukas Tribus [mailto:luky-37 at hotmail.com]
Sent: Tuesday, May 12, 2015 12:39 PM
To: Michael Malitsky; cisco-nsp at puck.nether.net
Subject: RE: [c-nsp] Logs are empty

> Working with a brand new 2911, 15.4(3)M2. I can't get anything to show
> up in the logs.
> Neither monitor

Which is disabled via "no logging monitor", so that should be expected?



> nor buffer

The "show logg" contains 13 messages from the buffer logging. Do you expect
something else?


Lukas


_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/