[c-nsp] 3rd party dwdm 80km optics in asr 9001

[Ted Johansson]

Hi Gustav,

We use Skylane SPDTU080100D139 and we also tune the wavelength in the router run 5.3.3.
But you need to add "transceiver permit pid all" under the interface and "service unsupported-transceiver" globally.
I have seen that the interface may go up without that command, but if the link bounces it won't go up until it's configured.

Best Regards
Ted Johansson


-----Original Message-----
From: cisco-nsp [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Gustav Ulander
Sent: den 28 september 2016 12:42
To: 'cisco-nsp at puck.nether.net' <cisco-nsp at puck.nether.net>
Subject: Re: [c-nsp] 3rd party dwdm 80km optics in asr 9001

Hello.

Iam woundering if anyone has had issues running 3rd party optics in the built in optics ports of a ASR9001 .
We have some 80km DWDM optics that we get module is not supported for.
We tried with transceiver permit pid all. We have similar SR-MM modules installed in the same machine that is working as advertised.
Iam beginning to wounder if the ASR 9001 is more sensitive with the longrange optics?
We have been using the same optics in a couple of 6500 SUP2t with X2 converters without issues but we cant seem to be bale to get a link on the ASR9001.
We are running 5.3.3 on these routers which might be an issue also we haven't tried downgrade them to something earlier.
Perhaps others has had the same issue?

//Gustav

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

******** IMPORTANT NOTICE ********
The content of this e-mail is intended for the addressee(s) only and may contain information that is confidential and/or otherwise protected from disclosure. If you are not the intended recipient, please note that any copying, distribution or any other use or dissemination of the information contained in this e-mail (and its attachments) is strictly prohibited. If you have received this e-mail in error, kindly notify the sender immediately by replying to this e-mail and delete the e-mail and any copies thereof.

Tele2 AB (publ) and its subsidiaries (“Tele2 Group”) accepts no responsibility for the consequences of any viruses, corruption or other interference transmitted by e-mail.