[c-nsp] 10G SFP+ ASR9001 LOS
Florian Lohoff
f at zz.de
Tue Apr 4 07:48:34 EDT 2017
Hi,
for some month i see sporadic LOS on a 10G circuit from a ASR9001 to
one of our Upstreams. It began when i removed some media-converter
from single mode to multi mode inbetween so that a SFP+ 1310nm 10km
transceiver is now plugged into the ASR.
The LOS can be cured shut/no shut on the interface. What i see
in case of the outage is this.
So we have an input optical signal/power which is well within
the range of the transceiver. The tx laser is shut down with
-40dBm. But i have no clue whats going on. I tried replacing
the SFP+ which did not help (Although the SFP was from the same
lot). I switched ports on the ASR (Although same board). I replaced
cabling. All without success.
I tried
transceiver permit pid all
although the tranceiver has Cisco branding which typically
makes this unnecessary.
Are there more debugging possibilities to find the cause for
the laser shutdown? I still think the SFP is faulty but
that means the whole lot is broken in some respect.
IOS-XR 5.3.1 - ASR9001
PHY data for interface: TenGigE0/0/2/3
SFP EEPROM port: 3
Xcvr Type: SFP
Xcvr Code: SFP-10G-LR
Encoding: 64B66B
Bit Rate: 10300 Mbps
Link Reach 9u fiber (Km): 10000 meter
Link Reach 9u fiber (100m): 10000 meter
Vendor Name: FLEXOPTIX
Vendor OUI: 10.00.00
Vendor Part Number: P.1396.10 (rev.: A )
Laser wavelength: 1310 nm (fraction: 0.00 nm)
Optional SFP Signal: Tx_Disable, Tx_Fault, LOS
Vendor Serial Number: F786HTA
Date Code (yy/mm/dd): 15/01/28 lot code:
Diagnostic Monitoring: DOM, Int. Cal.,
Enhanced Options: SW RX LOS Mon., SW TX Fault Mon, Alarm/Warning Flags
MSA Data
0x0000: 03 04 07 20 00 00 00 00 : 00 00 00 06 67 00 0a 64
0x0010: 00 00 00 00 46 4c 45 58 : 4f 50 54 49 58 20 20 20
0x0020: 20 20 20 20 00 10 00 00 : 50 2e 31 33 39 36 2e 31
0x0030: 30 20 20 20 20 20 20 20 : 41 20 20 20 05 1e 00 40
0x0040: 00 1a 00 00 46 37 38 36 : 48 54 41 20 20 20 20 20
0x0050: 20 20 20 20 31 35 30 31 : 32 38 20 20 68 b0 03 8e
0x0060: 00 00 08 e5 a4 5e 15 18 : fc da 7a 37 c0 bb fe 3f
0x0070: a0 ba 4d 00 00 00 00 00 : 00 00 00 00 18 8e 05 9c
Thresholds: Alarm High Warning High Warning Low Alarm Low
Temperature: +90.000 C +85.000 C -20.000 C -25.000 C
Voltage: 3.600 Volt 3.500 Volt 3.050 Volt 3.000 Volt
Bias: 90.000 mAmps 80.000 mAmps 3.000 mAmps 2.000 mAmps
Transmit Power: 1.77830 mW (2.50005 dBm) 1.41250 mW (1.49988 dBm) 0.25120 mW (-5.99980 dBm) 0.19950 mW (-7.00057 dBm)
Receive Power: 1.25890 mW (0.99991 dBm) 1.12200 mW (0.49993 dBm) 0.03160 mW (-15.00313 dBm) 0.02510 mW (-16.00326 dBm)
Temperature: 26.332
Voltage: 3.205 Volt
Tx Bias: 0.002 mAmps
Tx Power: 0.000 mW (<-40.00 dBm)
Rx Power: 0.27750 mW (-5.56737 dBm)
Oper. Status/Control: Tx Disabled,
EEPROM Memory (A2 lower)
0x0100: 5a 00 e7 00 55 00 ec 00 : 8c a0 75 30 88 b8 77 24
0x0110: af c8 03 e8 9c 40 05 dc : 45 77 07 cb 37 2d 09 d0
0x0120: 31 2d 00 fb 2b d4 01 3c : 00 00 00 00 00 00 00 00
0x0130: 00 00 00 00 00 00 00 00 : 00 00 00 00 00 00 00 00
0x0140: 00 00 00 00 3f 80 00 00 : 00 00 00 00 01 00 00 00
0x0150: 01 00 00 00 01 00 00 00 : 01 00 00 00 00 00 00 70
0x0160: 1a 55 7d 34 00 01 00 00 : 0a d7 00 00 00 00 80 00
0x0170: 05 00 00 00 05 00 00 00 : 00 00 00 00 00 00 00 00
CLEI Code: COUIAR5CAA
Part Number: 10-2457-01 (ver.: V01 )
Temp/Alarm/Power Flags: COM, commercial 0C to 70C
Minimum Temperature: 0
Maximum Temperature: 70
Calibration Constants: LBC Scale, Temperature, Laser bias current, Output power,
Product Id: SFP-10G-LR
EEPROM Memory (A2 upper)
0x0180: 43 4f 55 49 41 52 35 43 : 41 41 31 30 2d 32 34 35
0x0190: 37 2d 30 31 56 30 31 20 : 01 00 46 00 00 00 00 c9
0x01a0: 00 00 00 00 00 00 00 00 : 00 00 85 99 8f 00 a8 3b
0x01b0: d4 4b 00 00 1e 00 0a 98 : 13 51 0f e2 00 00 aa aa
0x01c0: 53 46 50 2d 31 30 47 2d : 4c 52 20 20 20 20 20 20
0x01d0: 20 20 20 20 31 31 00 00 : 00 00 00 00 00 00 00 2b
0x01e0: 14 1b 20 20 20 26 20 26 : 00 00 00 00 00 00 00 00
0x01f0: 00 00 00 00 00 fb 00 00 : 00 00 00 00 00 00 00 00
OPTICS:
Rx LOS Fault : No
Tx Fault : No
PHY:
Tx Align Fault : No
PMA/PMD:
Rx LOS Fault : No
Rx PMA link Fault : No
PCS:
Rx PCS link Fault : No
Rx PCS lock Fault : No
MAC:
Rx Local Fault : No
Rx Remote Fault : Yes
--
Florian Lohoff f at zz.de
UTF-8 Test: The 🐈 ran after a 🐁, but the 🐁 ran away
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 828 bytes
Desc: Digital signature
URL: <https://puck.nether.net/pipermail/cisco-nsp/attachments/20170404/9a3830a0/attachment.sig>
More information about the cisco-nsp
mailing list