[c-nsp] Cisco 891F modem flow control

[kouji.baba at orange.com]

While I am testing modem on Cisco891F, when I try to get long output, such as "show tech-support", many characters are dropped and cannot get correct log.
It seems flow control between internal modem and line of 891F is not working.
The part of config for line 3 (allocated to modem) is as below.

line 3
 modem InOut
 modem autoconfigure discovery
 no activation-character
 transport input all
 transport output all
 speed 115200
 flowcontrol hardware

I used same config for Cisco1921 with WIC-1AM-V2, but there is no problem on flow control.
I tried using several IOS from 15.3M to 15.7M, but every version had this problem.
Is there any other command to enable flowcontrol on the Cisco891F?

Best Regards,
--------------------
Kouji Baba (Orange Business Services Japan)


_________________________________________________________________________________________________________________________

Ce message et ses pieces jointes peuvent contenir des informations confidentielles ou privilegiees et ne doivent donc
pas etre diffuses, exploites ou copies sans autorisation. Si vous avez recu ce message par erreur, veuillez le signaler
a l'expediteur et le detruire ainsi que les pieces jointes. Les messages electroniques etant susceptibles d'alteration,
Orange decline toute responsabilite si ce message a ete altere, deforme ou falsifie. Merci.

This message and its attachments may contain confidential or privileged information that may be protected by law;
they should not be distributed, used or copied without authorisation.
If you have received this email in error, please notify the sender and delete this message and its attachments.
As emails may be altered, Orange is not liable for messages that have been modified, changed or falsified.
Thank you.