[c-nsp] MPLS/VPLS gear with ext.temperatures

[Patrick Cole]

Rob,

You will be hard pressed finding the feature set you are after in a hardened
low touch router.  ASR920 -IM series has some limited IPsec support as you 
have discovered.  There is the Juniper ACX500, but the encryption 
throughput is probably quite throughput limited - probably mostly designed
for management and things I would expect.

Regards,

Patrick Cole <z at wwwires.com>
Senior Network Specialist
World Without Wires
PO Box 869. Palm Beach, QLD, 4221
Ph:  0410 626 630
Mon, Jan 02, 2017 at 10:08:55PM +0100, Robert Hass wrote:


> On Mon, Jan 2, 2017 at 7:59 PM, Lukas Tribus <luky-37 at hotmail.com> wrote:
> 
> > >There is basic IPsec support afaik, I'm not sure about MPLS over
> > >GREoIPSEC though.
> >
> 
> Do you know if this box supports MACsec ?
> IPsec is useless as it's very limited - according to documentation:
>     Packet size greater than 1460 is not supported on IPsec tunnel.
>     IPsec traffic acceleration is supported only for UDP-TCP traffic.
>     Tunnel mode is only supported.
>     Volume-based rekeying is not supported.
>     IPv6 traffic is not supported on IPSEC tunnels.
>     Multicast Traffic is not supported on IPSEC tunnels.
>     IPsec tunnels are not supported on MPLS cloud.
>     IPsec tunnels are not supported on vrf lite.
>     QoS is not supported for IPsec tunnels.
> 
> Maybe other device from ASR line ?
> 
> Rob
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>