[c-nsp] ASR-920 10g License question

Ted Johansson ted.johansson at tele2.com
Tue Jun 6 16:20:41 EDT 2017


There are 4*10G ports that operate in 1G mode by default. To operate in 10G mode, you have to activate 10 GigabitEthernet Upgrade license with single bundle or two bundles.

When you install and activate with the single bundle (bundle count 1), then the first two ports are enabled in 10G mode (Interfaces Te0/0/2 and Te0/0/3 only).

If you install the second bundle (bundle count 2), all the 10G ports (Te0/0/2 - Te0/0/5) are enabled in 10G mode.

  *

Ports enabled by default: Te0/0/2 - Te0/0/5(operating in 1G mode)

  *

Licensed ports: Te0/0/2 - Te0/0/5 (license needed for 10G mode available in bundles of 2 ports)

Source http://www.cisco.com/c/en/us/td/docs/routers/asr920/configuration/guide/csa/b_port_licensing_asr920.html

Best Regards
Ted Johansson

Sent from my Phone

On 6 Jun 2017, at 20:41, Nick Cutting <ncutting at edgetg.com<mailto:ncutting at edgetg.com>> wrote:

I have 4 x 10g ports on one of our ASR-920-4SZ-A's

I am using 2 of them, but want to use the other 2.
Does the 10g license do all 4 - or pairs of two ports?

Index 5 Feature: 10GEupgradelicense
       Period left: Life time
       License Type: Permanent
       License State: Active, In Use
       License Count: 1/1/0  (Active/In-use/Violation)
       License Priority: Medium
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net<mailto:cisco-nsp at puck.nether.net>
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

******** IMPORTANT NOTICE ********
The content of this e-mail is intended for the addressee(s) only and may contain information that is confidential and/or otherwise protected from disclosure. If you are not the intended recipient, please note that any copying, distribution or any other use or dissemination of the information contained in this e-mail (and its attachments) is strictly prohibited. If you have received this e-mail in error, kindly notify the sender immediately by replying to this e-mail and delete the e-mail and any copies thereof.

Tele2 AB (publ) and its subsidiaries (“Tele2 Group”) accepts no responsibility for the consequences of any viruses, corruption or other interference transmitted by e-mail.


More information about the cisco-nsp mailing list