[c-nsp] WS-X6716-10GE in a 7600

[Jared Mauch]

I’ve found if you go a few rounds with Cisco they will blame 3rd party, then realize their driver is buggy and fix.

Or you have a bad card :-)

I’d opt for the latter, but the former does occur at times.

- Jared

> On Sep 6, 2017, at 7:57 PM, Bryan Holloway <bryan at shout.net> wrote:
> 
> I should add that these are genuine Cisco optics, and they work in other modules within the same chassis.
> 
> 
> On 9/6/17 6:07 PM, Bryan Holloway wrote:
>> Anyone have any experience using a WS-X6716-10GE-3C in a 7600 chassis?
>> The docs indicate that support was added in IOS 15.2(2)S ... we're running 15.5(3)S1.
>> Card boots fine, diagnostics pass, and interfaces appear in the config.
>> However, known working X2 GBICs we install show up as "Unknown", and the "sh int transceiver" output shows very odd values (e.g., -18.1 Celsius temperature (!) and 2231.8 mA (!) of current.)
>> Curious if anyone has used this module in that chassis successfully.
>> Should we just assume we have a bum card?
>> Thank you,
>>             - bryan
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/