[c-nsp] Connect "normal" Service instance to Vlan on Switch module

Nick Cutting ncutting at edgetg.com
Mon Nov 19 10:38:51 EST 2018


Thank you - I didn't even notice that. The command completed

I still doesn't populate the mac address table for Vlan901, I don't think this can be done without a physical cable.

-----Original Message-----
From: cisco-nsp <cisco-nsp-bounces at puck.nether.net> On Behalf Of Aaron1
Sent: Friday, November 16, 2018 5:20 PM
To: Nick Cutting <ncutting at edgetg.com>
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] Connect "normal" Service instance to Vlan on Switch module

This message originates from outside of your organisation.

Ambiguous because dot1 could be dot1ad or dot1q ?

Aaron

> On Nov 16, 2018, at 3:14 PM, Nick Cutting <ncutting at edgetg.com> wrote:
> 
> I am not sure if this is possible.
> 
> I have an ISR1111 (IOS XE, 16.8)
> 
> And I have a working service instance bridging the two WAN ports
> 
> interface GigabitEthernet0/0/0
> no ip address
> negotiation auto
> service instance 901 ethernet
>  encapsulation untagged
>  bridge-domain 901
> 
> interface GigabitEthernet0/0/0
> no ip address
> negotiation auto
> service instance 901 ethernet
>  encapsulation untagged
>  bridge-domain 901
> 
> I want to connect these two WAN ports to the switching module / WLAN 
> module Which has a switchport config, not a routed port config
> 
> interface Wlan-GigabitEthernet0/1/4
> switchport trunk native vlan 600
> switchport trunk allowed vlan 600,692,901 switchport mode trunk
> 
> or:
> 
> interface GigabitEthernet0/1/1
> switchport access vlan 901
> switchport mode access
> spanning-tree portfast
> 
> I cannot seem to connect the L3 BDI 901, or use a traditional SVI to 
> "tap into" the L2 vlan 901
> 
> I was hoping to use:
> 
> interface GigabitEthernet0/0/0
> service instance 901 ethernet
> encapsulation untagged
>  rewrite ingress tag push dot1 901
> 
> but the command will not complete, even though it question marks to a 
> <cr>
> 
> % Ambiguous command:  "rewrite ingress tag push dot1 901 "
> ROUTER(config-if-srv)#rewrite ingress tag push dot1 901 ?
>  <cr>          <cr>
> 
> 
> Anyone else have any ideas?
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/



More information about the cisco-nsp mailing list