[c-nsp] ASR9K HSRP Configuration

[Mohammad Khalil]

Greetings all
I am trying to bring up HSRP between ASR9Ks who are connected through bundle ether to N5K

RP/0/RSP0/CPU0:New9K1A#  sh run int Gi0/0/1/14
Fri Aug 28 01:38:25.742 CST
interface GigabitEthernet0/0/1/14
 description 5k1 - Eth1/1
 bundle id 405 mode active
 cdp
 speed 1000
 carrier-delay up 0 down 0
 transceiver permit pid all
!

RP/0/RSP0/CPU0:New9K1A#  sh run int Gi0/0/1/15
Fri Aug 28 01:38:27.157 CST
interface GigabitEthernet0/0/1/15
 description 5k2 - Eth1/1
 bundle id 405 mode active
 cdp
 speed 1000
 carrier-delay up 0 down 0
 transceiver permit pid all

I have established bundle ether 405 in between:

interface Bundle-Ether405
 description Bundle to NEW-NEXUS5k-1 & 2 - Eth1/1-2 (To use 10G later)
 lacp switchover suppress-flaps 300
 mlacp iccp-group 1
 mlacp switchover recovery-delay 60
 mac-address 5.5.5
 bundle wait-while 100
 bundle maximum-active links 4 hot-standby
 load-interval 30

RP/0/RSP0/CPU0:New9K1A#sh bundle bundle-ether 405
Fri Aug 28 01:39:16.413 CST

Bundle-Ether405
  Status:                                    Up

ICCP is up and running:

RP/0/RSP0/CPU0:New9K1A#sh iccp group 1
Fri Aug 28 01:39:45.368 CST
Redundancy Group 1
  member ip:10.255.255.250 (New9K1B), up (connected)
    monitor: route-watch (up)
  backbone interface Te0/0/2/0: up
  backbone interface Te0/0/2/1: up
  backbone interface Te0/0/2/2.15: down
  enabled applications: mLACP
  isolation recovery delay timer: 30 s, not running

I have established sub interface on the bundle ether:

interface Bundle-Ether405.3106
 vrf sme
 ipv4 address 10.95.10.125 255.255.255.224
 encapsulation dot1q 3106

On the 2nd ASR9K:
interface Bundle-Ether405.3106
 vrf sme
 ipv4 address 10.95.10.126 255.255.255.224
 encapsulation dot1q 3106

HSRP is not coming up:

BE405.3106     3359 110 P Active  local           unknown        10.95.10.97

BE405.3106     3359 100   Init    unknown         unknown        10.95.10.97

Am I missing something?

Thanks